FIXES 124799
LICENSE IPL10
Install symlinks for the *.krb versions of klog, pagsh, and tokens to the
non-krb versions and add information about the *.krb versions to the
non-krb man pages.
When using the install-sh that ships with the source tree, Autoconf
substitutes in a relative path just to be annoying. Define the INSTALL
variables in each individual Makefile so that they find the proper file.
Remove the definitions from Makefile.config so that no one will
accidentally get the wrong ones.
Initial cut at an HTML conversion of the POD reference pages. Requires
Pod::Simple be installed (version 3.0 or later, probably). Also fix a POD
formatting bug in the afs(1) man page noticed while testing HTML output.
On installation, substitute the configured paths into the man pages,
replacing the Transarc paths. Also fix a problem with the way that
pinstall was being used to install man pages. (Silly me, I was assuming
it had the same behavior as install.)
This is just a quick first pass. Longer term, it's probably better to
replace all paths in the man pages with unambiguous tokens and then
replace those tokens instead of assuming that the man pages use Transarc
paths and replacing those paths specifically. The current method has a
few minor problems, such as not being able to distinguish between the
various paths that make up /usr/afs/bin. Still, the results of this method
are good enough to start with.
Generate the man pages in man1, man5, and man8 subdirectories rather than
directly in the doc/man-pages directory to reduce clutter. Add a
.cvsignore to reduce noise.
This is the initial conversion of the AFS Adminstrators Reference into POD
for use as man pages. The man pages are now generated via pod2man from
regen.sh so that only those working from CVS have to have pod2man
available. The Makefile only installs. The pages have also been sorted
out into pod1, pod5, and pod8 directories, making conversion to the right
section of man page easier without maintaining a separate list and allowing
for names to be duplicated between pod5 and pod1 or pod8 (which will likely
be needed in a few cases).
This reconversion is done with a new script based on work by Chas Williams.
In some cases, the output is worse than the previous POD pages, but this is
a more comprehensive conversion.
This is only the first step, and this initial conversion has various
problems. In addition, the file man pages that didn't have simple names
have not been converted in this pass and will be added later. Some of the
man pages have syntax problems and all of them have formatting errors. The
next editing pass, coming shortly, will clean up most of the remaining
mess.
