mirror of
https://git.openafs.org/openafs.git
synced 2025-01-18 15:00:12 +00:00
6ace773fdc
The rx/perf test can occasionally fail due to the rxperf server not being fully initialized before the client started. This can cause test errors, even without changes to the rx code. C_TAP_VERBOSE=1 make check TESTS="rx/perf" ... rx/perf 1..4 ok 1 - Started rxperf server not ok 2 - single threaded client ran successfully RPC: threads 30, times 1, write bytes 1048576, read bytes... ok 3 - multi threaded client ran succesfully ok 4 - Server exited succesfully FAILED 2 (exit status 1) Add a routine that waits for the rx_perf server to become available. Loop several times trying the connection via the rx_perf client, with a short delay between retries. If the connection cannot be established, fail the test. Clean up trailing whitespace on a couple of lines. Note: This failure was observed in an OpenAFS buildbot worker that included a make tests, and which would occasionally fail when there was no rx related code changes. The intermittent failure could be duplicated on a slower virtual test system, but would not fail on a faster system. Thanks to mmeffie@sinenomine.net for the 'wait_for_server' contribution. Change-Id: Ie11e0d726ce287c45a677f3bb799388121aafc1e Reviewed-on: https://gerrit.openafs.org/15676 Tested-by: BuildBot <buildbot@rampaginggeek.com> Reviewed-by: Benjamin Kaduk <kaduk@mit.edu> Reviewed-by: Andrew Deason <adeason@sinenomine.net> |
||
|---|---|---|
| .. | ||
| .gitignore | ||
| atomic-t.c | ||
| event-t.c | ||
| Makefile.in | ||
| perf-t | ||